RCX 10A ESC Brushless Motor Speed Controller (Programmable / DYS)
chevron_left chevron_right

RCX 10A ESC Brushless Motor Speed Controller (Programmable / DYS)

$7.99 免稅

$7.99 未稅

$9.99 - $2.00

notifications_active 最後庫存

Same HobbyWing program for Airplane and Helicopter.

Programmable Features
  1. Brake Setting:Enabled / Disabled, default is Disabled
  2. Battery Type:Li-xx(Li-ion or Li-poly) / Ni-xx(NiMH or NiCd),default is Li-xx.
  3. Low Voltage Protection Mode(Cut-Off Mode): Soft Cut-Off (Gradually reduce the output power) or Cut-Off (Immediately stop the output power). Default is Soft Cut-Off.                                                           
  4. Low Voltage Protection Threshold(Cut-Off Threshold):Low / Medium / High, default is Medium.
    1. For lithium batteries, the number of battery cells is calculated automatically. Low / medium / high cutoff voltage for each cell is: 2.6V/2.85V/3.1V. For example: For a 3 cells lithium pack, when “Medium” cutoff threshold is set, the cut-off voltage will be: 2.85*3=8.55V.
    2. For nickel batteries, low / medium / high cutoff voltages are 0%/45%/60% of the startup voltage (i.e. the initial voltage of battery pack), and 0% means the low voltage cut-off function is disabled. For example: For a 10 cells NiMH battery, fully charged voltage is 1.44*6=8.64V, when “Medium” cut-off threshold is set, the cut-off voltage will be:8.64*50%=4.3V。
  5. Startup Mode:Normal /Soft /Super-Soft, default is Normal.
    Normal is preferred for fixed-wing aircraft. Soft or Super-soft are preferred for helicopters. The initial acceleration of the Soft and Super-Soft modes are slower in comparison, usually taking 1 second for Soft startup or 2 seconds for Super-Soft startup from initial throttle advance to full throttle. If the throttle is closed (throttle stick moved to bottom) and opened again (throttle stick moved to top) within 3 seconds of the initial startup, the restart-up will be temporarily changed to normal mode to get rid of the chances of a crash caused by slow throttle response. This special design is very suitable for aerobatic flight when quick throttle response is needed.
  6. Timing:Low / Medium / High, default is Low.
    Usually, low timing value can be used for most motors. We recommend the Low timing value for 2 poles motor and Medium timing value for motors with more than 6 poles to get a high efficiency. For higher speed, High timing value can be chosen.
  • Continuous Current: 10A
  • Burst Current: 12A (current over 13A will cause the ESC failure - burn)
  • Input Voltage: Lipo 2-3 Cells (2S is recommended)
  • Input Voltage: NiMH NiCd 6-16.8V
  • BEC: 5V  2A
  • Size: 26mm (L) * 23mm (W) * 7mm (H).
  • Weight: 12g
  • MCU: Atmega
  • Suitable SimonK Firmware: tgy.hex (if you want to flash it by yourself)
  • Download PDF English Manual
Designed for
  • Airplane and Helicopter
Package includes:
  • 1 x RCX 10A ESC Brushless Motor Speed Controller (Programmable / G Series)

** Please make sure your motor is not over demanding the current which can be supported by the ESC (10A Current Max, Burst Current is 12A in 10 seconds).

chat 評論 (0)