HappyModel Mobula6 ELRS 1S 65mm Brushless FPV Brushless Whoop Drone (2.4GHz ExpressLRS SPI)
zoom_out_map
chevron_left chevron_right

HappyModel Mobula6 ELRS 1S 65mm Brushless FPV Brushless Whoop Drone (2.4GHz ExpressLRS SPI)

$99.99 No tax

$99.99 Tax excluded

check Available

ExpressLRS is currently the most popular remote control link system. It has the characteristics of low latency and high packet rate, and its link quality is very reliable. Now we are about to release Mobula6 equipped with ExpressLRS RC link system, the new Mobula6 elrs would coming out with a new 0702 brushless motor, that would be the lightest brushless motors all over the world. We're sure this would be a good option for you in the Tiny Whoop Season. 
















Features

  • AIO Flight controller with ELRS Receiver and 5.8G VTX
  • Super light 1S 65mm Brushless whoop only 18.7g
  • Equipment with the lightest brushless motors-SE0702 only 1.46gram
  • Runcam Nano3 The lightest 1/3 CMOS 800TVL Camera
  • Smooth and powerful
  • Compatible for 1S Lipo/LIHV

Specifications

  • Brand Name: Happymodel
  • Item Name: Mobula6 ELRS 1S 65mm Brushless whoop drone BNF version
  • Wheelbase: 65mm
  • Size: 80mm*80mm*37mm
  • Weight: 18.7g

Receiver option

  • 2.4GHz ExpressLRS SPI receiver
  • 915MHz ExpressLRS Serial-based receiver
  • 868MHz ExpressLRS Serial-based receiver

Spare parts specifications:
Motor:

  • Mode: SE0702 KV26000
  • Configu-ration:9N12P
  • Stator Diamter:7mm
  • Stator Length:2mm
  • Shaft Diameter:Φ1mm
  • Motor Dimension(Dia.*Len):Φ9.5mm*14mm
  • Weight(g):1.46g
  • No.of Cells(Lipo):1S only

Propellers:

  • HQprop31mmx2
  • Center Thickness:5mm
  • Prop Disk Diameter:31mm
  • Center Hole Inner diameter:1.0mm
  • Weight:0.2g

 

Flight Controller:

  • ELRS F4 2G4 flight controller built-in SPI expresslrs 2.4G receiver
  • CrazyF4 ELRS flight controller built-in 915MHz expresslrs receiver
  • CrazyF4 ELRS flight controller built-in 868MHz expresslrs receiver
  • MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
  • Sensor: MPU-6000(SPI connection)
  • Board size: 28.5 * 28.5MM
  • Power supply: 1S battery input (DC 2.9V-4.35V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G VTX
  • Built-in ExpressLRS 2.4G/915MHz/868MHz receiver
  • Built-in 5V 1A BEC
  • Built-in voltage detection

 

Onboard 4in1 ESC

  • MCU upgraded to EFM8BB21
  • Power supply: 1S LiPo/LiPo HV
  • Current: 5A continuous peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory firmware: O_H_5_REV16_7.HEX
  • Default protocol: DSHOT600

Onboard SPI ExpressLRS 2.4GHz Receiver

  • Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
  • RF Frequency: 2.4GHz
  • Antenna : SMD antenna
  • Telemetry output Power: <12dBm
  • Receiver protocol: SPI ExpressLRS
  • Could bind with Happymodel ES24TX , ES24TX Lite, ES24TX Slim and DIY 2.4GHz ELRS TX module ExpressLRS version 1.0.0 or 1.0.1 both compatible

Onboard Serial-based ELRS Receiver

  • Operation current: ~100Ma
  • Rx To FC protocol: CSRF
  • RF Frequency optional: 915mhz or 868mhz(EU)
  • Antenna connector:  IPEX4
  • Telemetry output Power: <17dBm
  • Firmware target: Happymodel_RX_ES915RX
  • Receiver protocol: CRSF
  • Could bind with Happymodel ES915TX , Frsky R9M and DIY ELRS TX module(need to flash the same version ELRS firmware)
  • Firmware flash via Betaflight pass-through

Onboard 5.8g VTX

  • Output power: 25mw~200mw
  • Frequency: 40CH
  • Input voltage: 3.3V 5.5V
  • Current consumption: 300mA(type)
  • Frequency: 5.8GHz 5bands 40 channels
  • With Race band
  • Smartaudio ready

 

Runcam Nano3

  • Model: RunCam Nano 3
  • Image Sensor: 1/3" CMOS
  • Horizontal Resolution: 800TVL
  • Lens: 2.1mm(M8) FOV 160°
  • Signal System: PAL/NTSC Non Switchable
  • S/N Ratio: >50dB
  • Electronic Shutter Speed: Auto
  • Auto Gain Control (AGC): Auto
  • Min. Illumination: 0.01Lux@1.2F
  • D-WDR: Auto
  • Day/Night: Color
  • Power:DC 3-5.5V
  • Current: 110mA@5V 120mA@3.3V
  • Housing Material: ABS
  • Net Weight: 1.2g
  • Dimensions: L14mm*W14mm*H9mm

Lipo Battery

  • Capacity:300mAh
  • Voltage:3.8v
  • Continuous Discharge Rate: 30C
  • Size: 57mmx12mmx7mm
  • Weight: 8g
  • Connector: PH2.0

Pacakge Included:

  • 1*Mobula6 1S 65mm whoop Drone Frame (Color will be either Blue or Green, we will randomly ship)
  • Receiver - 2.4GHz ExpressLRS SPI receiver
  • 4*SE0702 KV26000 brushless motor
  • 1*HQPROP 31mm bi-blade propellers(4cw+4ccw)
  • 1*Runcam Nano3 1/3 CMOS 800TVL camera
  • 1*Onboard 5.8G 25mw~200mw VTX
  • 4*1S 300mah 30C LiHV Battery
  • 1*1S Lipo/LIHV USB Charger
  • 1*Propeller disassemble tool
HAPPY-M6-ELRS-SPI
550g
chat Comments (0)