This is 1080P Camera for FPV, it shipped with easy to configure OSD Menu through the button so no extra OSD cable is required. People usually mount this camera to 180-250 frame directly with the screws.

The quality of this camera is better than HS1177 and close to RunCam Eagle. It is the best value for the money.

Mini Camera with mounting holes (so you can mount it with angle)

Designed for Realtime FPV - Light in Weight









Built-in OSD menu for you to configure easily through the button.



Do I Need PAL or NTSC Standard?
Modern TVs (the new ones) usually support both standards but some old TV would still either support PAL or NTSC. Some CCTV Appliances have the option to let you choose either PAL or NTSC standard to display and record. But it is always good to choose the standard that your country has implemented. Please visit below pages for more information and to find out the standard of your country.

• http://shop.sandbag.uk.com/OneGiantLeap/PALNTSCInfo.html
• http://ihffilm.com/videostandard.html
• http://en.wikipedia.org/wiki/PAL
• http://en.wikipedia.org/wiki/NTSC

** IMPORTANT: We test each camera using CCTV System in order to verify the standard after we receive the stock from the factory. However, please forgive us if you receive a different standard than you have selected since something we might mess up the standard but it is rare but it does not really matter if you are using the camera on FPV because you will have a choice to set the standard on FPV equipment.

• --

• Resolution: 1080P CCD 800TVL 
• Power Source: 5-24V
• OSD Supported
• No extra cable required
• Len: 2.1mm, Approx 145°
  
• Weight:
• Approx 15.8g net weight
• Approx 17.2g with stand
• Dimension: 25x25mm
• Mounting (Direct Screws on Both Sides): --mm

• 1 x Mini Digital FPV Camera
• 1 x Camera Stand
• 1 x FPV Cable

** You might see "Black & White Screen" or "Blinking Screen" if the PAL and NTSC are mixed up eg. You connect a PAL camera to NTSC CCTV Appliance.

** Warning: Please use a stable 12V UBEC (RCX07-313 RCX UBEC 3A) instead of connecting the camera directly to the power source (3S Lipo), it could damage the camera and no refund / replacement will be offered, so you better test the voltage and make sure it is 12V before using it. Each camera has been tested before shipping.

** Warning: Each camera has been tested by using CCTV system to make sure it is working properly because we need to manually adjust the Len to a "clear" level before locking it up by glue/screw. The camera will burn only if you connect the + / - cables wrongly to the camera or connect an over voltage power source. Please use the default cable shipped with the camera only because not all cameras have the same pin layout on the PCB. Due to this reason, exchange/refund will be offered only after the camera is returned back to us for inspection. Thank you for your kind attention.