This is the Flight Controller used by F4 RacerCube but it can also be used standalone with other ESC. However, you must becareful when wiring and soldering by yourself.

This FC does not have a PDB (Power Distribution Board) function. So you need to either use a 4-IN-1 ESC or an external PDB. However, this FC has BEC so you can connect 2-4S Li-Po directly to power up the board.









Omnibus F3

• With MPU6000 (6DOF Version) & SPI Connection
  
• IC STM32F405RGT6
• With 128Mb Flash(16M Byte) Blackbox
• Onboard 5V/1A BEC (Output)
  
• Onboard OSD
• Weight: 8g
• Size: 27x27mm
• Mounting: 20x20mm (M2.5)
• Factory said they use M2 Nylon Spacer & Screw
• Default Firmware: betaflight_3.1.0_OMNIBUSF4
• could be changed from time to time
• Onboard LC Filter
• Input Voltage: 2-4S Li-Po
• Support DSHOT
• Support SBUS/PPM/DSMX
• Set RX1 as connection port when SBUS/DSM is used
• DMS uses 3.3V
• SBUS/PPM uses 5V
• Support Buzzer / LED
• Support BLHELI ESC Programming
• Support Cleanflight & BetaFlight

Note

• Use RX1 as port when using SBUS & DSM
• DMS uses 3.3V Port
• SBUS & PPM use 5V Port

Package Included

• 1 x F4 Omnibus Fight Controller
• Cable is excluded from this package. Only the RacerCube / 4-IN-1 ESC shipped with cable.

** Warning: The default firmware shipped with the board has been tested and configured by the factory in working condition (factory flashed the board with tested firmware manually via USB). You will be responsible for damage (or any part of function not working) if you flash your own firmware. So you are recommended to use the default firmware which shipped with the board. Thank you for your understanding.

** BOOT: the boot pin on the flight controller is for DFU (the method to flash firmware), you need to short 3.3V and BOOT when you need to use this option. But please do not do it unless there is no choice. It could make your board inaccessible if there is any mistake. Do it at your own risk.